ECTEC Receiving Systems Product Summary
Model |
Type |
Operating Spectrum |
Description |
Design Application |
Mechanical |
|---|---|---|---|---|---|
RS4000 Crystal I |
Receiving system | 34 - 110 GHz | MMW-receiver and polarization detection system; OMT and lens antennas feed eight channel high performance heterodyne receiver with wide instantaneous bandwidth. | Signal verification on outdoor ranges | Customized for user; nominal cube with dimensions 30" x 30" x 36" (L x W x H); weight is 55 lbs |
RS7000 Air Wolf |
Monitoring system for over the air test ranges. | 20 - 3000 MHz, expandable up to 18 GHz and down to 80 KHz. | Phased array DF and monitoring antenna, non-scanning, high performance heterodyne channelized receiver, very wide instantaneous bandwidth for demodulation of wideband signals, onboard GPS and high performance data recording system with 1.5 TB of local storage. | Signal monitoring on outdoor ranges; high performance receive system applications, compliance verification, interference mitigation, etc. | Dual axle, off-road, self-contained trailer with environmentally controlled electronics enclosure; 10m retractable mast for phased array antenna. Trailer dimensions are 14' x 8' with 24 inch ground clearance. Tankered fuel for six days of continuous operation. Full-up weight 3800 lbs. Refuelable without shutdown (diesel electric generator). |
RS9000 CrossBolt II |
Stimulus and response receiving and measurement system | 20 -10000 MHz, expandable to 18 GHz | Programmable, four channels for signal generation, four channels for signal reception; high fidelity signal simulation for selective communications degradation. Multiple control tones for closed loop amplitude set-on. | Four synchronized channels, high dynamic range, network controlled, remote access, precision frequency and time domain measurements. On-board GPS and interfaces to standard Ethernet devices; programmable or directly controllable. | 7" x 7" x 7" (L x W x H), 9 lbs, all weather, ruggedized, battery powered or AC powered, designed for directional coupler interface or for custom antenna connection. |
